Are you seeing any differences in the water’s pressure or its quality? Your water well system could be acting up for a number of different reasons, but as a well owner, your greatest concern is probably that these problems are indications that the well is about to stop producing water altogether. If you are afraid that this may be the case, continue reading to learn the warning signs that your well is drying up and to determine whether or not you need to employ a water well contractor.
The water has a murky, sandy, or muddy appearance.
In order to prevent sand or silt from being brought to the surface and clogging your faucet, water pumps are normally installed approximately 20 feet from the bottom of the well. It is possible that your water levels are low and that the pump is too close to the bottom of the well if you see a lot of sand or mud in your water. This could be an indicator that your water levels are low. Having said that, this could also indicate that the screen covering the well is broken and needs to be replaced. In the event that this is the case, it is in your best interest to contact a qualified water well contractor as soon as possible, as sand and sediment put a significant amount of strain on well pumps. You don’t want a simple issue to snowball into a complex and costly one, do you?
Faucet is Sputtering
If you turn on the sink faucet and a strong jet of water and air shoots out, this could indicate that the water level in the well has decreased beyond the point where the pump can reach it. When there is not enough water for the well pump to draw up, it will take in more air, which will cause the pressure to build up at the end of the faucet. In this scenario, more gases could be pulled up from the ground and dissolved in your water. This is a possibility. If you notice that your water is cloudy or smells funny, you should get it examined by a water well contractor who may also treat it if necessary. It is also possible that the line that connects the well pump to your water system (also known as the drop pipe) is damaged and needs to be replaced. This scenario is less likely, but still a possibility.
There is a Decrease in Water Pressure
You shouldn’t let your anxiety get the best of you just yet because there are a lot of potential causes for the low water pressure. Low water pressure can be an indication of a number of different problems. The worst-case scenario is that your well is actually drying up, but it could also mean that your well pump is broken, that there is a problem with the valve, or that your pipe is clogged. In any event, the most prudent course of action is to get in touch with an experienced water well contractor as soon as possible in order to get to the bottom of the matter before any other damage can be done.
Problems are also being experienced by the neighbors.
If you and your neighbors share a well, you should inquire with them as to whether or not they are experiencing any problems. If they are, then there is most certainly a more serious issue that has to be handled as soon as possible. If the water at their location is not tainted in any way, the problem most likely lies with your filter.
The Cost of the Electric Bill Has Increased
If your water pump is broken or if one of your pipes is clogged, it will take your pump twice as much effort to provide water to your home’s plumbing system. This additional energy will be shown on your monthly power bill, which can be very unsettling. In the event that it is not your water pump or a clog, it could also be a check valve that has broken. In the event that your check valve becomes damaged, your system will begin to pump water back up into the well, which will send a signal to the pump to begin operating once more. Because of this on-again-off-again pattern, your pump can be operating for the complete twenty-four hours of the day without your knowledge.
What to Do in the Event That Your Water Well Dries Up
Even though your water well is running dry, that does not necessarily indicate that you will have to seal it off completely. To begin, it is likely that the location of your water pump in the well is incorrect, and as a result, there is water leaking out from underneath the pump. Get in touch with an expert to have the water well checked out and have them change the height of the pump for you if it’s too high. Call Lovewell & Waterworks Well Services to have a technician take a look if you discover that your water well is no longer producing water and you need to abandon the well. If you would want to connect to the city water supply, we can assist you get set up with the scheduling process and plug your well at the same time.